Loftfield, N.; Kästner, M.; Reithmeier, E.: 3D registration of depth data of porous surface coatings based on 3D phase correlation and the trimmed ICP algorithm. In: Proceedings of SPIE - The International Society for Optical Engineering 10333 (2017), 1033310. DOI: https://doi.org/10.1117/12.2269781
Zusammenfassung: | |
A critical factor of endoprostheses is the quality of the tribological pairing. The objective of this research project is to manufacture stochastically porous aluminum oxide surface coatings with high wear resistance and an active friction minimization. There are many experimental and computational techniques from mercury porosimetry to imaging methods for studying porous materials, however, the characterization of disordered pore networks is still a great challenge. To meet this challenge it is striven to gain a three dimensional high resolution reconstruction of the surface. In this work, the reconstruction is approached by repeatedly milling down the surface by a fixed decrement while measuring each layer using a confocal laser scanning microscope (CLSM). The so acquired depth data of the successive layers is then registered pairwise. Within this work a direct registration approach is deployed and implemented in two steps, a coarse and a fine alignment. The coarse alignment of the depth data is limited to a translational shift which occurs in horizontal direction due to placing the sample in turns under the CLSM and the milling machine and in vertical direction due to the milling process itself. The shift is determined by an approach utilizing 3D phase correlation. The fine alignment is implemented by the Trimmed Iterative Closest Point algorithm, matching the most likely common pixels roughly specified by an estimated overlap rate. With the presented two-step approach a proper 3D registration of the successive depth data of the layer is obtained. © COPYRIGHT SPIE. Downloading of the abstract is permitted for personal use only. | |
Lizenzbestimmungen: | Es gilt deutsches Urheberrecht. Das Dokument darf zum eigenen Gebrauch kostenfrei genutzt, aber nicht im Internet bereitgestellt oder an Außenstehende weitergegeben werden. Dieser Beitrag ist aufgrund einer (DFG-geförderten) Allianz- bzw. Nationallizenz frei zugänglich. |
Publikationstyp: | BookPart |
Publikationsstatus: | publishedVersion |
Erstveröffentlichung: | 2017 |
Die Publikation erscheint in Sammlung(en): | Fakultät für Maschinenbau |
Pos. | Land | Downloads | ||
---|---|---|---|---|
Anzahl | Proz. | |||
1 | Germany | 115 | 58,38% | |
2 | United States | 38 | 19,29% | |
3 | China | 13 | 6,60% | |
4 | Netherlands | 4 | 2,03% | |
5 | France | 4 | 2,03% | |
6 | United Kingdom | 3 | 1,52% | |
7 | Spain | 3 | 1,52% | |
8 | No geo information available | 2 | 1,02% | |
9 | Hungary | 2 | 1,02% | |
10 | Czech Republic | 2 | 1,02% | |
andere | 11 | 5,58% |
Hinweis
Zur Erhebung der Downloadstatistiken kommen entsprechend dem „COUNTER Code of Practice for e-Resources“ international anerkannte Regeln und Normen zur Anwendung. COUNTER ist eine internationale Non-Profit-Organisation, in der Bibliotheksverbände, Datenbankanbieter und Verlage gemeinsam an Standards zur Erhebung, Speicherung und Verarbeitung von Nutzungsdaten elektronischer Ressourcen arbeiten, welche so Objektivität und Vergleichbarkeit gewährleisten sollen. Es werden hierbei ausschließlich Zugriffe auf die entsprechenden Volltexte ausgewertet, keine Aufrufe der Website an sich.