Auflistung nach Schlagwort "Busbars"

Sortiert nach: Sortierung: Ergebnisse:

  • Impact of Ag Pads on the Series Resistance of PERC Solar Cells 
    Schulte-Huxel, Henning; Witteck, Robert; van Laak, Paula; Brendemühl, Till; Hinken, David; Bothe, Karsten; Brendel, Rolf (London : Elsevier Ltd., 2016)
    Screen-printed passivated emitter and rear cells (PERC) require Ag pads on the rear side to enable solderable connections for module integration. These Ag pads are separated from the silicon by a dielectric layer to avoid ...
  • Impact of contacting geometries on measured fill factors 
    Kruse, Christian N.; Wolf, Martin; Schinke, Carsten; Hinken, David; Brendel, Rolf; Bothe, Karsten (London : Elsevier Ltd., 2017)
    The fill factor determined from a measured current-voltage characteristic of a bare solar cell depends on the number and positions of the electrical contacting probes. Nine different geometries for contacting the front ...
  • Reduction of Thermomechanical Stress Using Electrically Conductive Adhesives 
    Geipel, Torsten; Rendler, Li Carlos; Stompe, Manuel; Eitner, Ulrich; Rissing, Lutz (Amsterdam : Elsevier, 2015)
    We compare the thermomechanical stresses in solar cell interconnections based on electrically conductive adhesives (ECA) with soldered joints by using bending experiments and finite element analysis (FEA). Additionally, ...
  • Single Print Metal Stencils for High-efficiency PERC Solar Cells 
    Hannebauer, H.; Falcon, T.; Cunnusamy, J.; Dullweber, Thorsten (London : Elsevier Ltd., 2016)
    Industrial silicon solar cells like Passivated Emitter and Rear Cells (PERC) typically apply a screen-printed (Ag) front contact with a single print process using a mesh screen. It has been shown that using stencils instead ...