Auflistung nach Schlagwort "Metal forming"

Sortiert nach: Sortierung: Ergebnisse:

  • Residual stresses in grinding of forming tools with toric grinding pins 
    Grove, Thilo; Lucas, Henning; Denkena, Berend (Amsterdam : Elsevier B.V., 2018)
    The subsurface residual stress state of forming tools is an important factor for the lifetime of these tools. This is especially important for tools used in processes like sheet-bulk metal forming, where very high process ...
  • Shortening tool setting time for transfer presses 
    Behrens, Bernd-Arno; Doege, E.; Krimm, R. (London : SAGE Publications Ltd., 2006)
    The production processes of sheet metal products with complex geometries often use transfer presses to obtain fully formed workpieces from a single machine. The job of adjusting a new multistage tool set increases with the ...
  • Ultrafast lasers in ophthalmology 
    Lubatschowski, Holger (Amsterdam : Elsevier B.V., 2010)
    Ultrafast laser pulses have become a promising tool for microsurgery of the eye. Due to the low energy threshold, side effects are limited to the micrometer range This precision enables the use of ultrashort laser pulses ...
  • Wear Behavior of MoS2 Lubricant Layers during Sheet Metal Forming 
    Behrens, Bernd-Arno; Maier, Hans Jürgen; Hübner, Sven; Bonk, Christian; Almohallami, Amer; Lummer, Christin; Schein, Patrick; Scheland, Hannes; Micke-Camuz, Moritz (London : Elsevier Ltd., 2017)
    The increased use of high and ultra-high strength steel and materials with a high adhesion tendency leads to higher demands regarding the wear resistance of forming tools. A promising approach addressing both challenges ...